How to run with PMDG 737NGX without fuel and PAX

[Joeflyer]

As stated earlier, I cannot comment on how GSX works since I don't use the program. Have you inquired on their forum if they have one?

Regarding your last question above:

In order to make FsPassengers works with the PMDG NGX
In FsPassenger setting first page (General Setup):
Go to FSPX Folder then BIN Folder. Execute Aircraft Browser. See if PMDG 737 NGX is inside the list. Close it
Then launch FSX. In FSP Menu
Go to "Manifest Dialog" line, and choose "do not show the load After aircraft manifest laod"....don't forget to hit "Save"
in PMDG 737 NGX - Go to the "FS Action Menu" in the FMC: Load the fuel needed for your flight plan
in Playload Page (FMC): Click on SET EMPTY (0 passenger and 0 cargo)

ONLY after all this
Launch FSPassenger. (Fuel is already configured, just add your passengers and cargo)

I good look at the first Sticky at the top of this forum would certainly have cleared up your questions except for GSX part.



Post Edited ( 05-30-14 05:31 )