Add-on scenery airport not showing on GPS, thus not in FsP either

[AltairZQ]

I have this airport calle LEHI in a scenery. It can be seen both in FS9 and FSNav just fine. It can also be searched in FS9-Go to airport, selecting
add-on scenery. BUT, it's not on the GPS-nearest, and I've read from Dan that FsP gets the airport from there. So I get the:

Passenger Opinion: Mostly uneventful apart from a few moments. (78%)
-Are angry because they didn't reach their planned destination.

So I'd like to know what makes an airport show on FSNav and not on GPS? Is it something I could fix editing some configuration file?

[SaVas]

Not sure if it will help but see if there is an AFCAD file available for DL on AvSim

[DanSteph]

suprisingly I don't know where come the GPS data of Fs9 (I mean wich file they are on)
I would say as Savas from the afcad file but I'm not sure. (I'm not a scenery specialist)

Dan

[AltairZQ]

Thanks for the replies (sorry I forgot).

Still clueless about that

[Ryanamur]

Another option would be NOT to set a destination for those flights. That way you won't get dinged for landing at the wrong destination.

[QF6024]

Had the same issue
I have been building my own airstrips(OK a mate as well) for Western Australia -all the small ALA's.
Any way when they are created they were identified but would not show on GPS or the map for inclusion on routes.
However as soon as I created an afcad file up she pops. The creation is not difficult either.

[AltairZQ]

Ok... seems like making an AFCAD is the only way, will try to. Thanks a lot.

[olseric]

The actual data displayed in your GPS comes from a seperate XML compiled BGL file. The airport should show up by just making an
AFCAD, but the procedures and such have to be "hand-coded" and compiled.