Building crash...?

[Mick]

Hi Dan!

Think I found another strange thing :-)

After a very successful flight I was standing with my ERJ-145 at the gate 111 at EDDM, my passengers have been unboarding. Meanwhile I was looking
from the outsideview a little bit around the airport. Suddenlu FSP announce me a building crash :-(
The parking break was set and the aircraft definitely was not moving at all. All FS9 crash detection was disabled.

Any idea?

MfG.Mick!

[SaVas]

this is a common occurrence within the sim. Your plane may not be touching a building but it detects a crash. best thing is to STAY in
cockpit or panel view until all the pax are gone and you have saved, or dont park near buildings.
Disable FS9 crashes too (not FsP crashes)
Not sure what causes it other than the coords of the plane and building may cross over a little.

[SWAFO]

SaVas wrote:
Disable FS9 crashes too (not FsP crashes)

The crash and collision detection features of FSP simply FORCE FS9's crash detection. They're not seperate (as far as I understand). If
you're going to disable FS9 crash detection, be sure to disable FSP's as well. That way, you'll certainly be operating safetly without the
chance of a buggy collision or crash!

[olseric]

I had the same thing happen to me twice tonight (after unloading and ending FSP flight)...

You know what it was? The outside camera hit the building and caused a detected crash. Had to do that three times before I caught on
to what was happening.

[SWAFO]

The "virtual" camera hit the building! LMAO!