01-08-2005, 12:03 PM
Just a hint:
How you lean the mixture of the small stock-cessnas is explained in the FS2004-Help.
Here a quick explanation:
You set-up the proper mixture of the Cessnas by watching the EGT-needle (somwhere on the left of the panel). As you pull out the mixture-stab (however
it is called), the EGT raises until it reaches a specific peak and then it falls again. The right EGT-setting is shortly before the needle reaches
it's maximum when raising. Hope you understand, what I mean, as far as I know was this procedure also in another thread of this forum explained.
Greetings
Felix
How you lean the mixture of the small stock-cessnas is explained in the FS2004-Help.
Here a quick explanation:
You set-up the proper mixture of the Cessnas by watching the EGT-needle (somwhere on the left of the panel). As you pull out the mixture-stab (however
it is called), the EGT raises until it reaches a specific peak and then it falls again. The right EGT-setting is shortly before the needle reaches
it's maximum when raising. Hope you understand, what I mean, as far as I know was this procedure also in another thread of this forum explained.
Greetings
Felix
![[-]](http://www.fspassengers.com/forum/images/collapse.png)